M3-R1 &T1

TEL: 01883 622778

sales@xls.co.uk




	User Guide V 3.3 Download User Guide (V3.3) SaTerm Terminal Software SATEL M3 R1 T1 Configuration tool SATEL Configuration Manager V.1.04 (.zip file) For SATELLINE-M3-R1 and M3-T1 modules to change the product settings and configurations. Note! Save all the files to the same folder. In order to use this program the modems must have the firmware xxxx.35 or later. The firmware downloads can be found below firmware M3_R1 Firmware M3 T1

The SATELLINE-M3-R1 is a radio receiver module specifically designed for GPS (RTK) correction.

Consisting of a data modem and UHF radio receiver on a single PCB board. It can be supplied with or without a housing making it simple to integrate into any system. It is fully compatible with the SATELLINE 3AS and has a choice of RS232 or LVTTL interfaces. It is also compatible with Trimtalk and PCC protocols which allows integration to pre-existing installations.

Both channel width (12.5, 20, 25KHz) and frequency (402-470 mHz) are freely selectable.

The SATELLINE-M3-T1 is a Transmitter module consisting of a data modem and UHF transmitter on a single PCB board. It can be supplied with or without a housing. It has the same features as the R1.

	SateLLINE M3 R1	SATELLINE M3T1
Frequency Range	403-470 MHz
Channel Spacing	12.5 kHz/20kHz/25kHz
Tuning Range	67 MHz
Spurious Radiation	< 2nW
Frequency Error Tolerance	<3kHz
Sensitivity	-113..110dBm (BER<10 E-3) (FEC on)
Co channel Rejection	>10 dB (FEC on)
Adjacent Channel Selectivity	>45/50 dB (FEC on)
Intermodulation Attenuation	>55 dB (FEC on)
Blocking	74 dB (FEC on)
Radio Receiver
Spurious Rejection	60 dB (-100 dBm on GPS frequencies)
Spurious Emission	-57/-47 dBm
Typical Power Consumption	1.2W	3W @ 0.5 W output power 6 W @ 1W output power
Power Consumption, Sleep ON	0.24 W
Type of Emission		F1D
Carrier Power		0.5W and 1W
Adjacent Channel Power		According to EN 300 113 and CRF47 part 90
Carrien Stability		<+- 1.5dB
Data Modem
Timing	Rs232
Electrical Interface	Standard RS-232 or CMOS 3.3 V Inputs and Outputs (RTS CTS RX TX +VCC and GND)
Interface Connector	D-15 or customer specified
Data speed of I/O Interface	300-38400 bps
Data Speed of Radio Interface	19200 bps (25 kHz channel) 9600 bps (12.5/20 kHz channel)
Data Format Asynchronous	RS-232
Modulation	4FSK (optional GMSK)
General
Operating Voltage	+7.0...+30 Vdc (+/- 5%)
Temperature range	-25 deg C ..+55 Deg C
Antenna Connector	50 ohm (customer specific)
Construction	PCB with sheet metal EMI Shields
Size L x W x T	96mm x 56mm x 9mm
Weight	150g
ESD failure threshold	8kV contact, 15 kV air discharge


		Values are subject to change without notice

	This site uses Adobe .pdf files for more information go to www.adobe.com