SATELLINE Easy

SATEL RGB BIG

Same high standards of manufacture and reliability you’ve come to expect

Now you can roam the world with one unit and configure it to that countries regulations, easily keep stocks for your customers and have the same high standards of manufacture and reliability that you’ve come to expect from

SATEL

SATELLINE-EASy

is equipped with a wide, user selectable 70 MHz tuning range between 403...473 MHz

Channel spacing is now user selectable as well, either 12.5, 20 or 25 kHz  and either +3...+9 Vdc or +6...+30 Vdc voltage level ranges ensure low power consumption. Thanks to the amazing receiver sensitivity, the output power of 1 W enables distances that go beyond similar products

The EASy is fully compatible with widely used and well known SATELLINE-3AS(d) radio modem family and can also be included in systems based on other manufacturers’ protocols.

SATELLINE-EASy family modems are now available also with AES128 bit encryption 

If you would like this in an IP housing see the EASy-Proof

If you would like this in an IP with battery pack see Compact Proof!


 

Satelline Easy Manual V9.1

 SATELLINE-EASy and -EASy 869 user guide 

General Information

3D View

 



SATELLINE-EASy complies with the following international standards:

o EN 300 113-2

o EN 301 489 (EMC-requirements)

o EN 60950 (Safety Standard)

o FCC CFR47 section 90

o EN 61000-4-3 (2006), 10V/m Immunity test

 

SATELLINE-EASyTechnical Spec

 

  • Frequency Range 403...473 MHz
  • Channel Spacing 12.5 kHz / 20 kHz / 25 kHz
  • Tuning range 70 MHz
  • Spurious Radiations < 2 nW EN 300 113 and CRF47 part90
  • Frequency error tolerance < 1 kHz
  • Sensitivity -114 dBm @ 12.5 kHz -111 dBm @ 25 kHz (BER < 10 E-3)  FEC ON See: Note 1
  • Co-channel Rejection >-12 dB FEC ON
  • Adjacent Channel Selectivity > 47 dB @12.5 kHz > 52 dB @ 25 kHz FEC ON
  • Intermodulation Attenuation > 60 dB FEC ON
  • Spurious Rejection > 60 dB FEC ON
  • Spurious Emission < -100 dBm (Receiver) < -80 dBm on 3rd harmonics@1215 – 1240 MHz
  • Power Consumption < 1.2 W <3 W @ 0.5W output power <7 W @ 1W output power
  • Power Save Mode Consumption SLEEP State:0,24 W typical DTR: 0,005W
  • Communication Mode Half-Duplex
  • Type of Emission F1D (Transmitter)
  • Carrier power 100, 200, 500, 1000 mW  (Transmitter)
  • Adjacent Channel Power EN 300 113 and CRF47 part90  (Transmitter)

Carrier power stability

< 1.5 dB (Transmitter)

 

DATA MODEM

  • Timing RS-232
  • Electrical Interface PORT 1:RS-232 (fixed) PORT 2: RS-232/RS-422, LVTTL, TTL PORT 2

functions are delivery options

  • Interface Connector D-15 (female)
  • Data speed of I/O-interface 300 – 38400 bps
  • Data speed of Radio Interface 19200 bps (25 kHz channel) /9600 bps (12.5 kHz channel)
  • Data Formats Asynchronous data
  • Modulation 4FSK, GMSK, (PacificCrest, TRIMTALK *) (TRIMTALK is a trademark of Trimble Navigation Ltd.)

GENERAL

  • DC input ranges Nominal voltage : +3 … +9 Vdc or +6 … +30 Vdc Full range: +3.2 … +8.5 Vdc or +6.5 … +28 Vdc +/-10%. (Delivery options)
  • Temperature Ranges -30 C ... +65 C Functional -25 C ... +55 C Complies with standards, -40 C ... +80 C Storage
  • Antenna Connector 50 ohm, U.FL
  • Construction Aluminium housing - same as 3AS
  • Size L x W x T 96 mm x 56 mm x 9 mm
  • Weight 250 g
  • ESD-failure threshold 8 kV contact, 15 kV air discharge
  • Immunity test 10V/m

 

Note 1

Due to radio electronic design, the receiver is about 6 – 15 dB less sensitive on the following

frequencies:

403.000 MHz, 416.000 MHz, 429.000 MHz, 442.000 MHz, 455.000 MHz, 468.000 MHz,

409.5875 MHz and 469.200 MHz.


IMPORTANT! Please remember that it is the customers responsibility to ensure that the chosen radio frequency is clear and available for use, and that any required fees are paid and correct licences obtained.  Xl Systems Ltd. accepts no responsibility or liability for system failure or legal procedings either due to radio interference from a third party, or failure to comply to logal regulations.SATELLINE_EASyandEASy869WEB.pdf§

© XL Systems 2014